Shaft Position Sensor

Transmitters and Sensors : Shaft Position Sensor

The Shaft Position Sensor (SPS) is a general purpose feedback pot for actuator in applications such as firing rate feedback and fuel/air FGR.

Features
Overview
Specifications

0 - 100 % Boiler Firing Rate Signal
Sensor Used By Oxygen Trim, Furnace Draft or Other Controls That Require a Boiler Load Index
45 To 160 Degree Stroke Input Allows Installation Flexibility

The Shaft Position Sensor (SPS) is a general purpose feedback pot for applications that require firing rate feedback as a basis for establishing setpoints for other control loops such as Oxygen Trim or FGR Flow.

Stroke: 45 to 160 Degrees

Output: 1K Ohm Potentiometer

Enclosure: NEMA 12

Linkage Rod: 5/16" x 3' Linkage

Swivel Joint Connection: ¼ - 20 Threaded

DOCUMENTS
> Shaft Position Sensor - Catalog Cutsheet